Running Configuration
The currently active configuration script running on the router is referred to as the 'running-config' on the routers command-line interface. Note the privilege mode required. The running configuration script is not automatically saved on a Cisco router, and will be lost in the event of power failure. The running configuration must be manually saved with the 'copy' command (discussed in a later lab).
Router>
Router>enable
Router#show running-configBuilding configuration...
Current configuration:
!version 12.0!hostname Router
!interface Serial0
no ip address
shutdown
!interface BRI0
no ip address
shutdown
!interface Ethernet0
no ip address
shutdown
!line con 0
line aux 0
line vty 0 4
!end
Router#
If you decide you would like to start configuring a router from scratch you will need to reload the router making sure you have deleted your startup-config file that is stored in NVRAM. To do this you will need to first erase the configuration file you have in NVRAM using the command erase startup-config. Next you will need to reload the router and do not save the configurations when asked.
left#erase startup-
left#erase startup-config
Erasing the nvram filesystem will remove all files! Continue? [confirm][OK]Erase of nvram: complete
left#reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload? [confirm]
Copyright (c) 2001 Boson Software, Inc. All Rights Reserved.
No comments:
Post a Comment